Showing 8 results for Dielectric
S. Sagadevan, N. Nithya, R. Mahalakshmi,
Volume 13, Issue 1 (3-2016)
Abstract
The study of amino acid based nonlinear optical (NLO) materials with optimum physical properties is an important area due to their practical applications such as optical communication, optical computing, optical information processing, optical disk data storage, laser fusion reactions, laser remote sensing, colour display, medical diagnostics, etc. Also, microelectronic industries require crystals which possess low dielectric constant at higher frequency. Keeping this in view, attempts have been made to grow nonlinear optical crystals and study their optical, electrical and mechanical properties. Nonlinear optical single crystals of dichloro-diglycine zinc II have been grown by slow evaporation method. The grown crystals were characterized using single crystal X-ray diffraction, Fourier transform infrared spectroscopy (FTIR), UV-VIS-NIR spectrum, thermal, mechanical and dielectric studies. The results of characterization studies have been discussed in detail to understand their properties. The grown crystals have better thermal stability and sufficient mechanical strength. They are capable of inducing polarization due to dielectric behaviour when powerful laser beam is incident on them. The various characterization studies suggest that the grown crystals are promising materials for optoelectronic and nonlinear optical applications.
T. Ebadzadeh, S. Ghaffari, M. Alizadeh, K. Asadian, Y. Ganjkhanlou,
Volume 16, Issue 1 (3-2019)
Abstract
The densification behavior, structural and microstructural evolution and microwave dielectric properties of Li2TiO3 + xZnO (x = 0, 0.5, 1, 1.5, 2, 3, and 5 mol%) ceramics have been investigated using X-ray diffraction, Field Emission Scanning Electron Microscopy, Raman spectroscopy and microwave resonant measurement. The Maximum density of 3.33 g/cm3 was obtained in Li2TiO3 + 2ZnO ceramic at low sintering temperature of 1100˚C. SEM investigations revealed good close packing of grains when x = 2 and preferential grain growth when x ≥ 3. The maximum values of Q × f = 31800 GHz and εr = 22.5 were obtained in Li2TiO3 + 3ZnO and Li2TiO3 + 2ZnO compositions, respectively. The observed properties are attributed to the microstructural evolution and grain growth (first case) or high density of the obtained ceramic (second case).
Najwa Gouitaa, Lamcharfi Taj-Dine, Bouayad Lamfaddal, Abdi Farid, Mohamed Ounacer, Mohammed Sajieddine,
Volume 18, Issue 2 (6-2021)
Abstract
Najwa Gouitaa, Lamcharfi Taj-Dine, Abdi Farid , Ahjyaje Fatima Zahra,
Volume 18, Issue 3 (9-2021)
Abstract
In this study we have synthesis the Zr substituted BaTi0.80Fe0.20O3 ceramics at different content of Zr from x=0.00 to 0.10 by using the solid-state route. The room temperature X-ray diffraction results confirmed the coexistence of the two tetragonal and hexagonal phases for x ≤ 0.050 of Zr content. While above 0.050 the hexagonal phase disappears in benefit of tetragonal phase. The Raman results confirmed the formation of these phases obtained with XRD. The scanning electron micrographs consist of both spherical and straight grain forms for x=0.000 to 0.075, and only spherical grain form for x=0.100 attributed to the tetragonal phase. Also, the grain size increases accompanied with a decrease in density of ceramics with increasing Zr content up to 0.050 then decreases accompanied with an increase in density. Detailed studies of dielectric permittivity measurement have provided a presence of two anomalies Te and TR-O at different temperatures, with a relaxation phenomenon and diffuse behavior which is very important for ceramic at x=0.075 of Zr content. The dielectric permittivity values of the two anomalies of Zr substituted BaTi0.80Fe0.20O3 ceramics increase with increase of Zr content and the dielectric loss is minimal at x=0.100 of Zr content. The conductivity increases with the increasing of Zr substitution from 0.025 to 0.075 levels while for x = 0.100 the dielectric conductivity decreases. And the Cole-Cole analysis indicates a negative thermal resistivity coefficient (NTCR) behavior of these materials and an ideal Debye-type behavior.
Anas Al-Reyahi, Salem Yahya Degs, Ayman Issa, Zyad Khattari, Mohammed Abu Al Sayyed,
Volume 18, Issue 4 (12-2021)
Abstract
The structural properties of a natural clay sample (51% kaolinite) were tweaked to suit specific applications. H2SO4 and NaOH (1.0 M) treatment caused structural alterations and a significant release of Al ions compared to Si ions. Chemical treatment caused structural alterations, according to XRD analysis. FTIR analysis also indicated higher density of polar surface groups upon treatment which affected the corresponding dielectric behaviors. Dielectric measurements shown the suitable application of the materials either as dielectrical insulator and this dependent on the applied frequency. Acid treated kaolinite was reported to be a promising dielectric at 10 and 1000 Hz. With appropriate mass attenuation coefficients (μ/ρ) 12.098-12.182 cm2/g and a high half value layer of 10 cm at 10 keV, kaolinite and other treated forms were adequate shielding materials.
Surekha S. Jadhav, Amit A. Bagade, Tukaram J. Shinde, Kesu Y. Rajpure,
Volume 19, Issue 1 (3-2022)
Abstract
In present work Ni0.7Cd0.3NdxFe2-xO4 ferrite samples (0≤x≤0.03) were prepared by using oxalate co-precipitation technique. The different characterization techniques were achieved using X-ray diffraction (XRD), FT-infrared (FTIR) spectroscopy, scanning electron microscopy (SEM), DC electrical resistivity and dielectric measurements. The crystallographic parameters such as crystal structure, crystallite size, lattice constant, unit cell volume and theoretical density have been systematically analysed. The XRD and FT-IR measurements confirmed the formation of single phase spinel ferrite structure. The cation distribution among the octahedral and tetrahedral sites has been proposed on the basis of analysis of XRD patterns by employing Rietveld refinement analysis. The samples exist as a mixed type spinel with cubic structure. The DC electrical resistivity confirms the semiconducting behaviour and the Curie temperature decreases with increase in Nd3+ content. The dielectric constant and loss tangent decreases with frequency and higher frequencies remain constant, which shows the usual dielectric dispersion due to space charge polarization. The AC conductivity reveals that the small type polarons responsible for conduction process.
Ahabboud Malika, Najwa Gouitaa, Ahjyaje Fatimazahra, Lamcharfi Taj-Dine, Abdi Farid,
Volume 20, Issue 1 (3-2023)
Abstract
In this paper, Pb1-xFex(Zr0.52Ti0.48)O3 (PFZT) nanopowders, with x from 0.00 up to 0.20, were synthesized by using the sol-gel method. The PFZT samples were characterized by X-ray diffraction (XRD), Raman spectroscopy, scanning electron microscopy (SEM), and impedance spectroscopy. According to the experimental results, PFZT combines rhombohedral and tetragonal symmetries for all the samples without a change in phase structure. The SEM investigation indicated that the grains are homogeneous with regular form and the average grain size of PFZT ceramics changed with Fe concentration. The dielectric characterizations show that the dielectric permittivity increases with increasing temperature, and the Fe amount shifts down the temperature of transition. Moreover, a dielectric resonance phenomenon is observed for all the PFZT ceramics.
Ahabboud Malika, Gouitaa Najwa, Ahjyaje Fatimazahra, Lamcharfi Taj-Dine, Abdi Farid, Haddad Mustapha,
Volume 21, Issue 4 (12-2024)
Abstract
This paper reports the preparation and characterization of (1-x) PbZr0.52Ti0.48O3 -xBiFeO3 (1-x)PZTxBFO) (x= 0.00, 0.15, 0.30, 0.45, 0.60 and 1.00) multiferroic ceramics which were prepared by a sol-gel method for PZT and hydrothermal reaction process for BFO. The perovskite structure of the composite system was confirmed by X-ray diffraction and Raman spectroscopy, while the composite microstructure w:as char:acterized by scanning electron microscopy. XRD results and Rietveld analysis for the (1-x)PZT-xBFO composites confirm the coexistence of these three phases; rhombohedral (R3m) and tetragonal phases (P4mm) for pure PZT and only the rhombohedral phase (R3c) for pure BFO. Raman spectroscopy of the (1-x)PZT-xBFO composites shows two clear bands around 150 and 180 cm-1. When the BFO content increases, the intensities of Raman modes are decreased. The SEM results suggested a formation of agglomerate and form into large complex clusters as BFO increased and a higher grain size was obtained for the BFO sample compared with the other composites. The EDS spectra of our pellets show that all the characteristic lines of the chemical elements Pb, Zr, Ti, and O and Bi, Fe, and O are present for the PZT and BFO materials respectively. The temperature-dependent dielectric constant shows different behavior dependent on BFO content. Indeed, the dielectric properties are found to be improved with an increase in dopant concentration of BFO in PZT, and novel dielectric behavior, resonance, and antiresonance, were obtained.
