S. M. M. Shafiei, M. Divandari, S. M. A. Boutorabi, Naghizadeh,
Volume 12, Issue 2 (June 2015)
Abstract
In this work, TiN/TiCN & PN/TiCN multilayer films were deposited by plasma- assisted chemical vapour
deposition (PACVD). Plasma nitriding (PN) and TiN intermediate layer prior to coating leads to appropriate hardness
gradient and it can greatly improve the mechanical properties of the coating. The composition, crystalline structure
and phase of the films were investigated by X-ray diffraction. Atomic force microscopy and scanning electron
microscopy were employed to observe the morphology and structure of the films. The TiCN layer exhibited a columnar
structure. The adhesion force between the film and the tool steel substrate was 30.8 MPa for TiN/TiCN and 25.4 MPa
for PN/TiCN film determined by pull off tests. The hardness of TiN/TiCN film was 12.75 GPa while it was 5.4 GPa for
PN/TiCN film, respectively. The improvement of the adhesion in TiN/TiCN was attributed to a less gradient hardness
configuration. In addition, the mean friction coefficients of the films were about 0.2 for TiN/TiCN and 0.3 for PN/TiCN
film determined by nanoindentation tests.
Mahnaz Mohammadzadeh Mianji, Hossein Sarpoolaky, Mehrnoush Shafiei Sararoudi,
Volume 18, Issue 1 (March 2021)
Abstract
Translucent porcelain with appropriate workability has been considered beneficial for light and shadow to be used in the production of ceramic artworks. In addition, using low firing temperature encourages more artists to use this body. The soft-paste cellulose composite porcelain is composed of similar amount of high Borax/Calcia leadless frit and Kaolin with 3% Vee gum T as a plasticizer. In order to increase workability and green strength, five units of soft-paste porcelain (SP) slip was mixed by one unit bleached bagasse pulp of sugar cane slip in volume and then cellulose containing soft-paste porcelain (CSP) slip was made. The samples were formed by hand, dried and then fired at the optimum temperature of 1120 for 5 hours. Results showed that the SP sample became self-glazed after firing while cellulose increased porosity in CSP. Microstructure analysis showed a large amount of glass phase, which improved translucency of the bodies. Moreover, mullite needle-shaped crystals were derived from the flux-penetrated clay because of less viscous molten body matrix. XRD results clearly showed that the fritted soft-paste porcelain consists of quartz, mullite, anorthite and albite in the fired state. Spectrophotometry showed that adding cellulose to the porcelain body slightly increased translucency in the wavelength ranges 400 to 500 nm.
